If you have been following my journey of getting my drawloom up and working after 18 or so years, you may recall I was re-threading the loom from 8 shaft satin to 5 shaft satin, as I was having trouble with the counterweights not pulling the ground shafts back to neutral.
More than one drawloom weaver advised me to change from an 8 shaft satin to something using 4 or 5 shafts, so the decision was made to change to a 5 shaft satin.
After pulling 1,024 threads of 20/2 cotton out of the long-eye heddles (ground shafts) and maillons (pattern shafts), I was back at the lease sticks to again thread the the loom.
All was going well until I found a maillon with no threads. Disaster! I thought I had been watching so carefully, and now this meant having to yet again re-thread 1/4 of the maillons, then the long-eye heddles, approximately 256 threads. I tried to think if there was a way of moving the pattern heddles around on the pattern shaft bars, but as each pattern heddle was already tied to a drawcord, that would have meant untieing 1/4 of the drawcords, too. I decided against that.
Also unwilling to remove loom parts at this point, it meant bending over the side of the long back extension to re-thread those tiny holes. I should have owned stock in an ibuprophin manufacturing company over the past month! My aching back meant I could only work on this for short stretches at a time.
Yesterday, I finally finished re-threading the left side of the loom, left of the
center cords. Today, I’ve been threading the long-eye heddles on the right half of the loom, a job which goes fairly fast, and thankfully, went without incident.
There are 75 threads to go, and as I write this post and load in the photos, I’m on a stepstool moving heddles to the three shafts where I ran short. The re-threading will be completed in just a bit.
Yes, it has taken me quite awhile to reach this point (for the second time!). Yes, I want to weave on this loom sooner than later, but the more important goal is to understand the loom, the processes, what is happening and why (or why not), and figuring out what to do when things don’t go as planned. It’s been an interesting journey, and I’m looking forward to learning so much more.